Set of filters for the electric nail drill with Semilac dust collector (5 pcs.)

Set of 5 Semilac replaceable filters for absorbing dust when performing a manicure. Reusable filters are dedicated for the Semilac 2-in-1 No Dust electric nail drill with dust collector.

Main characteristics of the filters:

· Filter diameter: 17 cm

· Reusable.

· Easy cleaning.

· Simple replacement of the filter in the Semilac 2-in-1 No Dust electric nail drill with dust collector.

· The filters are made of non-woven fabric.

FILTER REPLACEMENT

• Make sure that the device is turned off, and then lift the filter upper cover with holes.

• Pull the fabric strip to pull out the whole filter.

• Insert a new filter and then replace the filter cover.

NOTE

• Disconnect the power supply if the dust collector is not used.

• If the filter cover is removed without first disconnecting the power supply, the device will stop working and go into security mode; the diode of the appropriate mode will start flashing. After the filter is replaced and the filter cover put back on, the device will work again.

• The filter is replaceable; it should be replaced after 2–3 months of operation and immediately in the case of damage.

In order to ensure the correct operation of the device, it is necessary to clean the filter frequently, preferably after each manicure. We remove dust gathered after working on the nail plate by blowing out the filter with compressed air or shaking it out.

• Do not soak or wet the filters.